Stainless Steel Grease Traps to trap fats, oils and grease. FOG  
img1
img1
img1
img1
img1
filtra trap sizes and installation
 
GTB Grease Traps come in a range of sizes relative to the through-put of water needed. They are designed to fit under standard sized work benches. If however space is an issue all are units are manufactured from rust free stainless steel and can be located externally.

The size / flow rate is the most important factor when choosing your grease-trap. The below chart is an excellent guide to what size you may need. Alternatively, if you are unsure contact one of our staff on 01325 460040.
grease trap dimensions
Model
Flow Rate
Application
A
B
C
D
E
GTB 37L
37 Litres
1-2 small commercial sinks and dishwasher.
380
330
350
280
270
GTB 45L
45 Litres
1-2 small / medium commercial sinks & dishwasher.
460
330
350
280
270
GTB 65L
65 Litres
1-2 medium / large commercial sinks & dishwasher.
660
330
350
280
270
GTB 85L
85 Litres
1-3 medium / large commercial sinks & dishwasher.
500
430
460
360
350
GTB 135L
135 Litres
2-3 large commercial sinks & dishwasher.
800
430
460
360
350
GTB 170L
170 Litres
large restaurants & hotels with multiple sinks & dishwasher.
1000
430
460
360
350
(In-Let Size 40mm, Out-Let Size 50mm)
Above Sizes Shown In Millimeters
how filtra trap works
 
Grease traps work on the basic principal that FOG’s (Fats, Oils & Grease) float on water and solid particles sink. As the inflow of waste water from the sinks enters the grease trap the fats, oils and greases rise to the surface and is trapped between the baffle plates.

The baffles on the outlet prevents FOG’s from flowing directly through the unit. These FOG’s are retained within the unit along with food particles and clean water flows under the baffle plates through the unit to drain. The retained waste collected within the unit can be easily removed at regular intervals using the removable fine mesh filter.

Grease Traps made from Stainless Steel
installation of a filtra trap
GTB Grease Traps are delivered fully assembled and couldn’t be easier to install. Just connect the pipe run from the sinks and dishwasher to the Grease Trap inlet. Then pipe the Grease Trap outlet directly to drain. We recommend solvent weld pipe is used for a secure fit.

We appreciate that in some kitchens there is little spare room for a grease trap, our design team will be happy to liaise with your drainage engineer or kitchen designer to incorporate the GTB Grease Trap in your development.

Also GTB Grease Traps can also be custom built to your specifications.
Grease Traps made from Stainless Steel
Grease Traps made from Stainless Steel
 
Website Designed by www.digital85.com
Privacy Notice | Conditions of Use | About Payments
All Rights Reserved 2011 | www.polytraps.com
Fatstrippa / Clear Flow - Please visit our website